Skip to main content
  1. We enter the following command in the Mainsail console: PID_CALIBRATE HEATER = extruder TARGET = 210 and confirm with Enter. The extruder now heats up to 210 degrees plus / minus several times and cools down in between.
    • We enter the following command in the Mainsail console: PID_CALIBRATE HEATER = extruder TARGET = 210 and confirm with Enter. The extruder now heats up to 210 degrees plus / minus several times and cools down in between.

    • When the tuning is finished, the determined values for Kp, Ki and Kd displayed. About Save Config the values are adopted.

    • Who primarily with PETG or similar prints, instead of the 210 °, a higher temperature, e.g. Specify 230 °.

    • The printer should be supervised during tuning!!

  2. We now enter the following command in the Mainsail console: PID_CALIBRATE HEATER = heater_bed TARGET = 60 and confirm with Enter. The heatbed now heats up to 60 degrees plus / minus several times and cools down in between.
    • We now enter the following command in the Mainsail console: PID_CALIBRATE HEATER = heater_bed TARGET = 60 and confirm with Enter. The heatbed now heats up to 60 degrees plus / minus several times and cools down in between.

    • When the tuning is finished, the determined values are again via Safe Config saved

    • The PID tuning takes significantly longer with the heatbed. Of course, other temperatures can also be specified here.

    • New line.The printer must not remain unattended during tuning!!

Finish Line

Abd Ghaffar Othman

Member since: 06/15/2024

1 Reputation

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 12