Manta M8P Klipper Installation

cd ~ && git clone https://github.com/th33xitus/kiauh.git

git clone https://github.com/Arksine/CanBoot

cd Canbbot

make clean

make menuconfig

make

cd ../klipper

make clean

make menuconfig

make

keep boot pressed, press reset, release reset, release boot

lsusb (board is in DFU mode)

sudo dfu-util -a 0 -D ~/CanBoot/out/canboot.bin --dfuse-address 0x08000000:force:mass-erase -d 0483:df11

sudo dfu-util -a 0 -d 0483:df11 --dfuse-address 0x08002000:force:leave -D ~/klipper/out/klipper.bin

sudo nano /etc/network/interfaces.d/can0

allow-hotplug can0 iface can0 can static bitrate 250000 up ifconfig $IFACE txqueuelen 1024

reboot

ifconfig can0

~/klippy-env/bin/python ~/klipper/scripts/canbus_query.py can0

insert the canbus-id into printer.cfg

cd ~/CanBoot

make clean

make menuconfig

make

keep boot pressed, press reset, release reset, release boot

lsusb

sudo dfu-util -a 0 -D ~/CanBoot/out/canboot.bin --dfuse-address 0x08000000:force:mass-erase -d 0483:df11

disconnect USB

connect EBB36 via Canbus connector and 24V

connect Manta to 24V

~/klippy-env/bin/python ~/klipper/scripts/canbus_query.py can0

cd ../klipper

make clean

make menuconfig

make

python3 ~/klipper/lib/canboot/flash_can.py -u 807f70702f20

Insert wisdom here.